Archive for October 31st, 2016

How to Restore Harwood Flooring

How to Restore Harwood Flooring

Have Damaged Wood Floors?

When you get wood flooring construction, you are making an investment in your home. It takes a lot of money, time, and effort to install wood flooring in your home. However, as is the case with any home, and any investment for that matter, it takes maintenance and care to keep looking nice. It is not an investment that you make and leave alone. If you have not taken good care of your investment and damaged your wood floor, or if your wood floor has diminished in color and shine, you are going to need to learn how to restore your hardwood flooring.

 

Clean and Prep

The first step for any flooring construction is to clean and prepare the area. You must have a clear working area, removing everything on the floor, including all furniture and rugs. You can use your favorite hardwood floor cleaning agent, or create your own using a mixture of 10 parts water to 1 part white vinegar. In order to prep the room, you must begin by sanding the perimeter of the room with 180-grit sandpaper. In order to most effectively prepare for the next steps, you should sand 4 to 6 inches away from the baseboards.

How to Restore Harwood Flooring

Scuff-Sand the Floor

Rather than trying to sand the entire floor by hand, it is best to use a buffer to sand the room as a whole. The prep done for the room is to ensure that all parts of the flooring are completed, including the parts that the buffer cannot reach. You can rent a buffer from your local home improvement store, and purchase the maroon buffing pads to it. If you need to read best information you should visit our link:http://www.tessandgary.com/factors-which-affect-home-construction/ here. Always wear a dust mask in order to protect yourself from any airborne dirt during this stage of flooring construction. Buff the floor in the direction of the grain, always keeping the buffer moving.

 

Vacuum and Tack

Once you have sanded the floor, you should give it about 10 to 15 minutes for all of the flooring powder to settle. This also gives you the chance for a much needed break. You should then use a Swiffer dry sweeper to sweep the floor, getting all of the powder off of the wood, and from in between any of the floor boards. After checking out this article click here for extra information. In order to complete this step of the flooring construction, you will need to ensure that you dry tack the floor using a microfiber cloth that you push against the grain.

 

Apply the Finish

Now is the stage of flooring construction in which you apply the finish to your now bare wood flooring. You should always begin by cutting into the corners and edges of the room. These are the areas of the floor that are going to be the hardest to reach. This job must be done very carefully. Once you have cut into the corners, you are ready to complete the rest of the floor. You can use a long-handled roller and roll out the finish across the rest of the flooring, always going with the grain.…

Continue reading